Annie Sloan Chalk Paint is known for breathing life into old pieces of furniture. Here, Annie shows us a simple project that's a perfect go-to if the kids are stuck indoors some rainy, winter afternoon!
“I used upholsterer’s piping cord to print this footstool because it is soft and absorbs the paint well," says Annie. "I also like the broken-line effect created by the rolled cord. You could use string instead of cord, if you wish, although you may find some types of string have a coating that stops the paint adhering at all, which means the print will be unsatisfactory. So, test a few different types before you get going. The block is simply a discarded piece of wood that was left over after making some shelves.
“You’ll discover that printing on a coloured fabric is better than printing on white fabric if you’re using quite strong colors. The fabric used here is a mid-tone, neutral, textured natural linen. Play around with making various patterns and using different colors on paper or scraps of fabric before committing to a design. Use a generous piece of fabric, so that you can select the best printed area for your upholstery.”
YOU WILL NEED:
- Small project pots of Chalk Paint® in Emperor’s Silk and Henrietta
- Wooden block
- Hot glue gun
- Upholsterer’s piping or soft cord
- Annie Sloan MixMat™
- Small flat brush
- Annie Sloan Coloured Linen in French Linen & Old White
- Rag cloth
- Iron and ironing board
1. Take the wooden block and apply a couple of spots of hot glue to one end. Wrap the cord around the wood and, as you wrap, allow it to be both slanted and straight. Add more spots of hot glue as you wrap. Pay attention to each side of the wood, so that you can use both sides for printing. The slanting of the cord is part of the joy. (Although hot glue isn’t essential, it does ensure that the cord doesn’t slip out of place and smudge the paint.)
2. Working on the MixMat™, apply an even layer of Emperor’s Silk to the cord with the flat brush. Before applying the paint to the fabric, check that the paint is even and printing well. The first prints are often a little uneven until the paint is properly absorbed by the cord.
3. Print rows of stripes in Emperor’s Silk first, leaving gaps between rows that are wide enough for the rows in the second color of Henrietta. Keep printing until the fabric is covered with the striped design.
4. Wipe off the excess Emperor’s Silk with the rag cloth and use the reverse side of the block for the Henrietta print.
5. Print the stripes in Henrietta in the gaps between the rows of red stripes. Once dry, iron the fabric to set the paint.
Annie Sloan Paints Everything is published by CICO Books and is available, from October 13th, at all good book stores, nationwide. Photography by Christopher Drake © CICO Books (€19.50)
